Why is my Kenmore bottom freezer refrigerator not cooling?
- Why is my Kenmore bottom freezer refrigerator not cooling?
- How do I reset my Kenmore bottom freezer refrigerator?
- How much does an evaporator fan cost?
- How do you troubleshoot a Kenmore refrigerator?
- Why is my Kenmore refrigerator not cooling?
- Why is my Refrigerator not getting cold enough?
- Why is my freezer not freezing?
Why is my Kenmore bottom freezer refrigerator not cooling?
If the refrigerator is not cold enough there might be something caught in the condenser fan motor blade, or the condenser fan motor might be defective. The condenser fan motor draws air over the condenser coils to cool them. The condenser fan motor is located underneath the refrigerator near the back.
How do I reset my Kenmore bottom freezer refrigerator?
Open one refrigerator door and press the “Ultra Ice” and “Home” buttons simultaneously for five seconds to turn off the refrigerator’s controls. Unplug the refrigerator’s power cord from the wall outlet. Reconnect the power cord to the wall outlet. The refrigerator is now reset.
What causes a Kenmore refrigerator to stop cooling?
Check the condenser coils to determine if they are dirty—if the condenser coils are dirty, clean them. The condenser fan motor draws air though the condenser coils and over the compressor. If the condenser fan motor is not working properly, the refrigerator won’t cool properly.
👉 For more insights, check out this resource.
How much does an evaporator fan cost?
Fridge Repair Cost by Type of Replacement
| Part | Replacement Cost (Labor Included) |
|---|---|
| Thermostat | $100 – $260 |
| Fan | $120 – $150 |
| Evaporator Coil | $200 – $300 |
| Ice Maker | $350 – $500 |
How do you troubleshoot a Kenmore refrigerator?
If your Kenmore side-by-side doesn’t run, ensure the cord is plugged firmly into the outlet and check your electrical panel. If the breaker has tripped, reset it. If there is power running to the appliance, your refrigerator may be in the defrost cycle and will run when it ends, which typically takes 30 minutes.
👉 Discover more in this in-depth guide.
How do I reset my Kenmore refrigerator after a power outage?
Another way you can reset certain Kenmore freezers is by pressing and holding the UP arrow button until the display finally starts showing 10 digits on the display. You will then need to press the Alarm reset button.
Why is my Kenmore refrigerator not cooling?
Your Kenmore refrigerator may not be cooling due to one of several commonly reported problems, including power supply issues, mistakes in the fridge setup or damage to the appliance. You can attempt to resolve your refrigerator’s cooling problems yourself by following some manufacturer-approved troubleshooting tips.
Why is my Refrigerator not getting cold enough?
The most common fridge “not cooling” problem is a frost free failure. Remove the access panel in the freezer section to expose the evaporator coils. If the coils in the freezer section get plugged up with frost, this frost will block the evaporator fan motor from blowing the cold air around.
Why is your refrigerator not cold?
On refrigerators with only one evaporator, the evaporator is located in the freezer compartment. If the evaporator fan is not working, it will not circulate the cold air to the refrigerator compartment. If this occurs, the freezer may still get cold, while the refrigerator will not get cold.
Why is my freezer not freezing?
Another common reason you may think the freezer is running but not freezing is improperly packing the contents. Situated behind a vent inside your freezer, typically in the rear, the evaporator fan circulates cool air.
